Agilent Technologies Video Gaming Accessories Agilent Technologies Video Gaming Accessories User Manual

0

Out of 0 Ratings

Owner's of the Agilent Technologies Video Gaming Accessories Agilent Technologies Video Gaming Accessories gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 128
 
Chapter 2 Quick Start
To Use the Power Supply in Constant Voltage Mode
28
To Use the Power Supply in Constant Voltage Mode
To set up the power supply for constant voltage (CV) operation, proceed as
follows.
For each step, use the keys shown on the left margin.
1
Connect a load to the desired output terminals.
With power-off, connect a load to the desired output terminals.
2
Turn on the power supply.
The power supply will go into the power-on / reset state; output is disabled (the
OFF annunciator turns on); the 15V/7A range is selected (the 15V annunciator
turns on); and the knob is selected for voltage control.
To operate the power supply in the 30V/4A range, press the key before
proceeding to the next step. The 30V annunciator turns on.
3
Set the display for the limit mode.
Notice that the
Limit annunciator blinks, indicating that the display is in the
limit mode. When the display is in the limit mode, you can see the voltage and
current limit values of the power supply.
4
Adjust the knob for the desired current limit.
1
Check that the Lmt annunciator still blinks. Set the knob for current control.
The second digit of ammeter will be blinking. The blinking digit can be changed
using the resolution selection keys and the blinking digit can be adjusted by
turning the knob. Adjust the knob to the desired current limit.
1
You can use the resolution selection keys to move the blinking digit to the right or
left when setting current.
In constant voltage mode, the voltage values between meter mode and
limit mode are the same, but the current values are not. Moreover if the
display is in the meter mode, you cannot see the change of current limit
value when adjusting the knob. We recommend that you should set the
display to "limit" mode to see the change of current limit value in
constant voltage mode whenever adjusting the knob.
Power
30V,4A
Display Limit
Volt/Curr

   Find Your Products By Category