Agilent Technologies Welding System Agilent Technologies Welding System User Manual

0

Out of 0 Ratings

Owner's of the Agilent Technologies Welding System Agilent Technologies Welding System gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 134
 
22
Quick Start
One of the first things you will want to do with your power supply is to become
acquainted with its front panel. Written procedures in this chapter prepare the
power supply for use and familiarize you with most front-panel operations.
• The power supply is shipped from the factory configured in the front-panel
operation mode. At power-on, the power supply is automatically set to
operate in the front-panel operation mode. When in this mode, the front-
panel keys can be used. When the power supply is in remote operation mode,
you can return to front-panel operation mode at any time by pressing the
key if you did not previously send the front-panel lockout command.
A change between front-panel and remote operation modes will not result
in a change in the output parameters.
• When you press the key (the Lmt annunciator blinks), the
display of the power supply goes to the limit mode and the present limit
values of the selected supply will be displayed. In this mode, you can also
observe the change of the limit values when adjusting the knob. If you press
the key again or let the display time-out after several
seconds, the power supply will return the display to the meter mode (the
Lmt annunciator turns off). In this mode, the actual output voltage and
current will be displayed.
• All outputs of the power supply can be enabled or disabled from the front
panel using the key. When the output of the power supply
is off, the OFF annunciator turns on and the three outputs are disabled.
• The display provides the present operating status of the power supply with
annunciators and also informs the user of error codes. For example, the +6V
supply is operating in CV mode and controlled from the front panel, then
the CV and +6V annunciators will turn on. If, however, the power supply is
remotely controlled, the Rmt annunciator will also turn on, and when the
power supply is being addressed over GPIB interface, the Adrs annunciator
will turn on. see
"Display Annunciators"
on page 5 for more information.
Throughout this chapter the key to be pressed is shown in the left margin.
Local
Display Limit
Display Limit
Output On/Off

   Find Your Products By Category