3M Automobile Accessories 3M PPS Sun Gun Color Matching Light System User Manual

0

Out of 0 Ratings

Owner's of the 3M Automobile Accessories 3M PPS Sun Gun Color Matching Light System gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 14
 
Low Battery Indicator
The 3M™ PPS™ Sun Gun™ Color Matching Light is configured with a voltage regulator
to insure that the proper spectral output of the lamp is maintained. Once the supplied
voltage drops to a predetermined level, the Low Battery indicator will illuminate to let the
user know that the 3M™ PPS™ SUN GUN™ Battery Pack needs to be recharged. The
3M™ PPS™ SUN GUN™ Battery Pack should be recharged at this time. The lamp will
continue to provide proper spectral output until the voltage regulator determines that the
supplied power is inadequate. At this time the unit will shut-down and the Low Battery
LED will remain illuminated. NOTE: When this occurs, the 3M™ PPS™ SUN GUN™
Battery Pack should be disconnedcted from the 3M™ PPS™ SUN GUN™ Light and
inserted into the 3M™ PPS™ SUN GUN™ Battery Charger. If the battery is allowed to
discharge further, the LED indicator will not illuminate and the switch will not turn on the
light. The 3M™ PPS™ SUN GUN™ Light will not function until the 3M™ PPS™ SUN
GUN™ Battery Pack has been fully recharged. This functionality has been implemented
to insure that the 3M™ PPS™ SUN GUN™ Color Matching Light always provides the
proper spectral output for its intended use.
Cleaning
Only use a mild soap solution on a damp cloth to clean the 3M™ PPS™ SUN GUN™
Light, Battery Pack, Battery Charger or Power Supply. Other cleaners may contain
chemicals that could cause damage to the plastic. Do not use flammable or combustible
solvents (refer to warning and caution instructions). Never let liquids get inside 3M™
PPS™ SUN GUN™ Light; never immerse any part of 3M™ PPS™ SUN GUN™ Light
into liquid.
Replacing the Light Bulb
To replace bulb, remove the lamp bezel by turning it counter-clockwise to release it from the
lamp housing. Grasp the edge of the bulb and depress slightly while turning counter-clockwise
to release the bulb from its socket. To install a new bulb, insert the bulb into the keyed socket
and depress slightly while turning the bulb clockwise until it is stops and is firmly seated.
Reinstall the lamp bezel by aligning it to the housing and turning clockwise until the bezel
engages the hooks and snaps into place. Note: To ensure safe and proper operation, use only
3M bulb (Part number 16399) in the 3M™ PPS™ Sun Gun™ Light.
7 8
Low Battery Indicator

   Find Your Products By Category