Powermatic Digital Photo Frame Tilting Table Hollow Chisel Mortiser User Manual

0

Out of 0 Ratings

Owner's of the Powermatic Digital Photo Frame Tilting Table Hollow Chisel Mortiser gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 24
 
10
Assembly
Do not connect the machine
to power source until completely
assembled. Read and understand the entire
manual.
Securing Machine to Stand
The mortiser should be secured to the stand
with four M8 x 45 hex cap screws and M8 lock
washers (provided) using the holes in the base.
Make sure there is enough room on each side
of the mortiser for the size stock you plan to
use.
Wooden Table
Referring to Figure 6:
1. Place the wooden table (A) in position on
the slide (B).
2. Secure with two Phillips head screws
provided (C).
Operating Handle
Referring to Figure 7:
1. Fasten operating handle (A) to the hub (B)
and tighten with a 14mm open-end wrench.
2. Raise mortising machine head to the up
position by moving the operating handle
(A) up.
Note: The handle assembly is spring-loaded
and can be repositioned by pulling out the
hub (B) and repositioning it on the pinion
shaft (C).
Figure 6
Figure 7

   Find Your Products By Category