Billy Goat Automobile Accessories DL1301H User Manual

0

Out of 0 Ratings

Owner's of the Billy Goat Automobile Accessories DL1301H gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 12
 
Part No 812379 Form No F060711B
8
DL12/13/14/18 Owner’s Manual
MAINTENANCE
PERIODIC MAINTENANCE
Periodic maintenance should be performed at the following intervals:
Maintenance Operation Every use Every 5 hours (daily) Every 10 Hours Every 25 Hours
Inspect for loose, worn or damaged parts.
z
Check engine oil and air filter
z
Clean hose
z
Engine (See Engine Manual)
Inspect battery for damage or leak
z
Keep engine free of debris
z
Check battery terminal for corrosion
z
Check for excessive vibration
z
INTERLOCK SYSTEM
With hose coupler installed (as shown in Fig. 8) the switch is open & engine is not grounded out, allowing engine to run.
IMPELLER REMOVAL
1. Wait for engine to cool and disconnect spark plug wires from the engine.
2. Remove the hose from the unit.
3. Unattach the hose from boom assembly.
4. Remove the intake housing assembly (item 16) by removing (6) locknuts (item 44). Be careful to
place intake assembly to the side without putting excess strain on safety switch wire harness
5. Remove impeller bolt (item 34), lock washer (item 35), and spacer (item 37) using 5/8" socket and
impact wrench (see fig. 6).
6. Once bolt is removed impeller should slide out freely. If the impeller doesn’t slide off freely use
penetrating oil and work the hub off using a pry bar. Do not use the pry bar on the impeller plate.
7. When impeller is free of the engine shaft, align impeller with the opening and pull it straight out of the
housing.
8. Using a new impeller bolt, washer, and lock washer, install new impeller in reverse order.
Note: Be sure that the key is in place on the engine shaft before installing impeller.
9. Tighten impeller bolt. Torque the impeller bolt to [33-38 Ft. Lbs. (45-52 N.m)]
10. Repeat steps 2 through 5 in reverse order.
11. Reinstall spark plug wires.
Fig. 8
Fig. 6
Hose must be
installed and switch
lever must engage
switch for engine to
start.
DL1801V SYSTEM
ENGINE
SWITCH
INTERLOCK
SWITCH
Spark plug
IGNITION
UNIT
Spark plug
IGNITION
UNIT
DL1201L SYSTEM
ENGINE
SWITCH
INTERLOCK
SWITCH
Spark plug
IGNITION
UNIT
Throttle
stop
DL1301H SYSTEM
DL1801VE SYSTEM
Spark plug
Spark plug
IGNITION
UNIT
IGNITION
UNIT
ENGINE
SWITCH
INTERLOCK
SWITCH
DL1401SE SYSTEM

   Find Your Products By Category