0

Out of 0 Ratings

Owner's of the Adam Equipment Postal Equipment Adam Equipment Postal Equipment gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 16
 
© Adam Equipment Company 2005 6
Overload display: When
FULL
appears on the display, it shows that
the load on the platform is over the maximum capacity. Under these
circumstances, it is necessary to reduce the load otherwise the sensor
or the platform will be damaged.
Hold Function: To lock the weighing result, press the [Hold] key. The
arrow indicator will point towards HOLD and it will the show a steady
reading even if the person on the platform is moving or goes away from
the scale and will not affect the next weighing. To release the function,
press the [Hold] key again.
Do not press the [On/Off] key if you do not want to weigh as pressing
the [On/Off] key will switch the scale to ON.
6.2 MEASURING HEIGHT
While measuring the height, it is necessary to pull up the measuring
board at a right angle with the inside tube.
When the tube is pulled out straight, it is sufficient to measure the
height form 70-126cm. The number can be obtained upon the conjoint
place where the upper part of middle tube screw meets with the inside
tube scale.
Further, if the middle tube is pulled out straight, it is possible to
measure the height from 126-190cm. The reading can be obtained at
the conjoint place where the upper part of outside tube screw meets
with the middle tube scale.
7.0 USER CALIBRATION
1. Press [On/Off] key when the display shows
SCALE
”.
2. Press [On/Off] key again.
If the display is not showing
Id01
open the upper housing and switch the
span jumper on PCB to ON.
Start again by pressing [On/off].
The display shows
Id01
”, “
Id-02
”, “
Id05
”, “
Id10
”,”
Id-20
”, “
Id-50
”.
3. Select
Id01
for 100g increments and press the [On/Off] key once.