3M Cordless Saw 3M Motor Lead Pigtail Splice User Manual

0

Out of 0 Ratings

Owner's of the 3M Cordless Saw 3M Motor Lead Pigtail Splice gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 4
 
78-8096-4634-8-F
3
Scotch
®
Linerless Rubber Splicing Tape 130C
Figure 4
Figure 5
3.3 FOR 8 kV ONLY. Cover the lugs and bolt with four half-lapped layers of Scotch
®
Linerless Rubber Splicing Tape130C (Figure 4).
Note:  Lug cover will be printed with 5 kV rating.  Mastic layer qualifies the part as 8 kV.
3.4 Install Lug Cover. Position Lug Cover so the punch holes are positioned between the cables (Figure 5).
Note:  The kit contains a small tube of Silicone Grease.  Use it to lightly lubricate the mastic and vinyl tape wraps.  This 
will aid in the installation of the Lug Cover.
3.5 Be sure that the punched holes are beyond the cable end of the mastic and vinyl tape wrap. Insert the plastic locking
pin through the holes (Figure 5).
Hint:  Inserting the pin from the back side of the Lug Cover will aid in visually aligning the pin through both holes.
3.6 Cut off excess pin length, if desired. (Leave at least
1
⁄
4
" extending from Lug Cover).

   Find Your Products By Category